Rather than just adding `Self` to the lexical scope, add it to the
class's name scope so that it is visible in later lexical scopes for the
same class -- in particular, for out-of-line definitions of members.
Also switch some tests in `check/testdata/class` over to making
idiomatic use of `Self` both inside a class and out-of-line, now that it
works more consistently.
Note that this does not permit using `Class.Self`, but only because we
don't yet support keyword names after `.` at all. If that changed, one
could use `Class.Self` to redundantly refer to `Class`. Whether we allow
that is left to a future decision.
Previously we used the default inst block formatting, which writes out a
parenthesized list of references, which would always be 'unexpected
instref's because nothing else prints the instructions in the decl
block.
In addition, track the decl block for function declarations like we do
for other kinds of declaration. This means that the parameter
declarations for a function are now properly rendered into the formatted
IR. Note that this adds a lot of verbosity to `function_decl`, but it
does accurately reflect the IR, and we'll probably want this information
to be printed once we start supporting more complex generic function
declarations.
This removes almost all the 'unexpected instref's in our formatted
output. There are remaining cases when a declarative scope contains
multiple blocks, where we only track one of those blocks. That happens
when there is control flow within declarative scopes, and for error
recovery when a class or interface or similar is defined more than once.
As requested in #3730.
By adding a constant to ClassDecl/InterfaceDecl, we're able to remove
name reference special-casing. Use TryEvalInst on the Decl to generate
the Type. For ClassDecl, then use the generated constant for
self_type_id.
Collect the contents of an `impl` into a scope, and start doing very
basic checking for `impl` declarations and definitions.
This change adds two new `Id` types to the set of type that `NodeStack`
supports -- `ImplId` and `NameScopeId`.
---------
Co-authored-by: Jon Ross-Perkins <jperkins@google.com>
Richard Smith
Jon Ross-Perkins