This has is a nice-to-have for me. Frequently I want to run a specific
test, and end up digging through output to be able to copy-paste the run
line. This uses TIP lines to inject the command into the file when using
AUTOUPDATE.
Note, one of the reasons I want this is because "bazel test
//toolchain/testing:file_test --test_output=all" has been regularly
exceeding bazel's output limit for me (workaround is either opening the
output file or specifying an obscure output limit flag), making it a
little harder for me to get the commands. However, frequently I'm adding
a file and want to iterate on it, so that's really the use case I have
in mind here.
Factor out `SemIR::InstNamer` and also use it when lowering to LLVM IR.
Automatically name all instructions created with our `IRBuilder` based
on the name computed by the `InstNamer`, and likewise name basic blocks
using the label generated by the `InstNamer`.
Move some of the existing naming logic out from lower into `InstNamer`
so that it's also used in SemIR. In particular, we now name call
instructions after their callee, or after the builtin name for calls to
builtins.
Computing and adding these names isn't completely free. This instruction
naming is designed to be optional, so that we can turn it off for builds
where the LLVM IR will only be converted to assembly and won't be seen
by a human, but so far it's enabled unconditionally. We can tune that
later as needed.
If the initializing representation is the same as the value
representation, don't materialize a temporary and perform a value
binding. Instead, directly extract the value, using a new
`value_of_initializer` node.
This removes a lot of redundant `alloca`s from our generated LLVM IR.
Trust semantics to have put them in the right places.
Many parts of lowering still need to be updated to use the value
representation chosen at the semantics layer, but this is an incremental
step towards that.
Jon Ross-Perkins
Richard Smith